 |
Description: 17-4 Stainless Steel 21 operations, mirror mount. Tolerances of .0002 for angularity and .0004 for position.
Size: 1.5" x 3" x 7"
|
 |
Description: 625 Inconel, Lathe and Milling, 8 operations
two lathe and 6 milling
Size: 7.00" diameter x 5.125 long
|
 |
Description: Machined from 4340 block and machined complete in 2 Rgh and 3 finish ops. Used on a reusable rocket program.
Size: 16" x 9" x 8"
|
 |
Description: 15-5 die forging machined
complete in 2 roughing and 2 finishing operations. End use is an engine
mount on Boeing 737-300 Commercial Aircraft.
Size: 4" x 4" x 12"
|
 |
Description: 15-5 Stainless Steel and ran complete in 3 operations.
Size: 4" x 4" x 7"
|
 |
Description: 15-5 Stainless Steel forging 8 operation multi set-up using customer supplied tooling.
Size: 4" x 4" x 12"
|
 |
Description: 7075 Aluminum substitute part to replace a casting that is no longer available. Made from solid. 8 operations to complete.
Size: 12" x 12" x 4"
|
 |
Description: Underwing front spare repair component made from 7075 Aluminum
Size: 8" x 12" x 3"
|
 |
Description: Made from 7075 Aluminum. Machined complete in 5 operations with all walls and floor +/- .005 tolerance.
Size: 10" x 14" x 2.5"
|
 |
Description: 7075 Aluminum used on Boeing 747 commercial aircraft. We also make many other variations of this part for other aircraft.
Size: 3" x 3" x 16"
|
 |
Description: Machined from 7075 Aluminum in 2 rough and 2 finish operations. Prototype part for Joint Strike Fighter Aircraft.
Size:10" x 20" x 3"
|
 |
Description: Made from 7075 Aluminum,
machined complete in 2 rough and 2 finish operations with .050 +/- .005
floors used to mount parachutes for a resusable rocket program.
Size: 9" x 56" x 3"
|
